Bay BayStack 400-ST1 Manuál s instrukcemi stáhnout pdf (Strana 30)

Adding Units to the Stack

This section describes how to add one or more units to the

middle of a stack or to the end of a stack.

Adding Units to the Middle of a Stack

To add one or more units to the middle of a stack,

complete the following steps:

1. Determine the position of the new units in the

existing stack (Figure 12

For example, the shaded units (units 5 and 6) in

Figure 12

show two new units to be added to the

stack. The new units are numbered as unit 5 and unit 6

because they are additions to an existing 4 unit stack.

2. Disconnect the cascade cable from the Cascade A

In connector at unit 3.

Leave the other end of the cascade cable connected to

the Cascade A Out connector at unit 2.

3. For 19-inch rack configurations, move the units

two spaces lower in the rack.

Note:

Refer to Using the BayStack 450

10/100/1000 Series Switch for information about

installing units on a tabletop or in a standard

19-inch utility rack.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Žádné komentáře

Bay BayStack 400-ST1 Manuál s instrukcemi Strana 30