Bay BayStack 400-ST1 Manuál s instrukcemi Strana 39
- Strana / 42
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
37
2. Remove the cascade cable from the Cascade A In
connector at unit 5.
3. Remove the units (units 3 and 4) and install
replacement units as required.
4. Renumber the order of the units for the new stack
configuration (if desired).
You can renumber the unit numbers as described in
your switch’s User Guide.
Removing/Replacing Nonadjacent Units
To remove/replace nonadjacent units from an operating
stack, complete the following steps (Figure 17):
1. Remove the cascade cable from the Cascade A In
connector at unit 3.
2. Remove the cascade cable from the Cascade A Out
connector at unit 3.
3. Remove the unit (unit 3) and install the
replacement unit as required.
4. Reconnect the cascade cables (removed in steps 1
and 2) to unit 3.
Note:
Remove and replace the units individually to
avoid segmenting the stack configuration.
- Installing the 1
- BayStack 400-ST1 1
- Cascade Module 1
- Introduction 3
- Contents of Shipment 6
- Cascade A InUnit Select 9
- Initial installation 11
- Temporary Base Unit 11
- Automatic failover 12
- Stack MAC address 13
- Stack Up Configurations 14
- Installation 20
- BayStack 450 and 410-24T 21
- 1 = Filler panel 22
- 2 = Cascade module slot 22
- Business Policy Switch 22
- Cascade A Out 23
- Cascade A In 23
- Unit Select 23
- (unit 1) 26
- 1 = Base unit only 30
- 2 = All other units in stack 30
- Modifying an Existing Stack 31
- Configuration 31
- Upgrading the Switch Firmware 41
Související produkty a manuály pro Sítě Bay BayStack 400-ST1
Sítě Bay BayStack 400-ST1 Uživatelský manuál
(33 stránky)
(33 stránky)
Gibson GCK95206XA Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Kochfelder Gibson GCK95206XA.
Wir stellen 1 PDF-Handbücher Gibson GCK95206XA zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Komentáře k této Příručce